1. When the tractor is driving in reverse, but the
tractor symbol is oriented to the front:
Select .
2. If the tractor is driving forwards, but the tractor
symbol is oriented to the rear:
Select .
11.7
Marking obstacles
1. "GPS switch" > .
The obstacle symbol is flashing on the map.
The length specification of the shift is shown
beside the obstacle symbol.
2. Using the directional pad, shift the obstacle
symbol to the desired position.
The obstacle symbol is moved by one metre each
time the button on the directional pad is pressed.
CMS-T-001600-A.1
11 | Using the GPS switch
Marking obstacles
MG5560-EN-II | E.1 | 21.04.2020
97
To Next Page
Loading...
