Using the job management
10
10.1
Managing jobs
Job management can be used to process jobs in ISO-
XML format. The ISO-XML jobs can be created with a
Farm Management Information System (FMIS) and
imported to the AMATRON 3 with a USB flash drive.
Alternatively, the jobs can be created and edited on
the AMATRON 3.
From a job in ISO-XML format, the field boundaries
and application maps can be processed with GPS
switch.
Two types of application maps can be imported:
Map type 1: This type of map is displayed on the
GPS switch map. The stored setpoints are
transmitted to the implement and processed.
Map type 2: This type of map is not displayed on
the GPS switch map. The stored setpoints are
transmitted to the implement and processed.
When a job has been started on the AMATRON 3, the
field boundaries and the application map are
displayed on the GPS switch map and the job data is
recorded. The recording of job data depends on the
created ISO-XML job and the connected implement.
Among others, the following job data can be
recorded:
Application/spread rates
Application positions
Operating time of tractors and implements
The finished jobs can be exported and further
processed with a Farm Management Information
System (FMIS).
CMS-T-00004677-B.1
CMS-T-00004698-A.1
10 | Using the job management
MG5560-EN-II | E.1 | 21.04.2020
53
To Next Page
Loading...
