Amazone AMATRON 3 - Adjusting the Volume

REQUIREMENTS
The AMATRON 3 is in ISOBUS mode, see
page 15
1. Select "Setup" > "Settings" > "Basic settings".
Possible settings:
: When the vehicle ignition is switched on or off,
the AMATRON 3 is switched on or off.
: The AMATRON 3 must be switched on and off
manually.
CMS-I-002050
2. Enable or disable ignition switching
7.1.3
Adjusting the volume
In this menu, the volume of the signal tones can be
adjusted.
1. Select "Setup" > "Settings" > "Basic settings" >
"Volume".
2. Enter a value between 1 and 20.
3. Confirm the entry.
NOTE
The AMATRON 3 cannot be muted.
CMS-I-001519
CMS-T-005131-A.1
7 | AMATRON 3 configuration
Entering the basic settings
MG5560-EN-II | E.1 | 21.04.2020
20