After switching on
5
5.1
Selecting the BUS mode
After starting the AMATRON 3, it is possible to select
between 2 BUS modes. The selection of the BUS
mode depends on the connected implement.
BUS modes:
AMABUS
ISOBUS
NOTE
After 10 seconds, the AMATRON 3 automatically
starts in the previously selected BUS mode. If the
AMATRON 3 should start directly in the previously
selected BUS mode, the corresponding mode
must be activated in the setup, see page 30.
CMS-T-00004671-A.1
CMS-T-003915-A.1
MG5560-EN-II | E.1 | 21.04.2020
15
To Next Page
Loading...
Need help?
General
