11.14.6 Configuring the application map
If "Application maps" was selected when importing
the field data, further settings must be entered.
1. Select the values for the application/spread rate.
2. Select the units for the application/spread rate.
3. If all of the values should be increased or
reduced by a
specific percent value,
select and enter the percent value.
4. If a specific value should be changed,
select the value from the list and enter the new
value. Example: Application/spread rate should
be increased by 10 %, enter 110 % and confirm.
CMS-I-001549
The application map will be imported.
NOTE
To be able to use the application map for an ISO-
XML job, a job must be added to the application
map as a setpoint.
CMS-I-001550
11.15
Using the driver assistance system
Switching delays of the seed drill and uneven forward
speeds can cause overlap or underlap in the seed
rows. The driver assistance system supports the
driver in working the field seamlessly. The driver
assistance system notifies the driver with a signal
tone and a symbol that the vehicle is approaching the
switch point and that the forward speed must be kept
constant.
CMS-T-005142-A.1
CMS-T-005190-A.1
11 | Using the GPS switch
Using the driver assistance system
MG5560-EN-II | E.1 | 21.04.2020
124
To Next Page
Loading...
Need help?
General
