2. If the receiver is installed to the right of the
centre of the axle,
enter a positive value for the distance between
the GPS receiver and the centre of the axle under
"A"
or
If the receiver is installed to the left of the centre
of the axle,
enter a negative value for the distance between
the GPS receiver and the centre of the axle under
"A"
3. If the receiver is installed in front of the centre
of the axle,
enter a positive value for the distance between
the GPS receiver and the centre of the axle under
"B"
or
If the receiver is installed behind the centre of
the axle,
enter a negative value for the distance between
the GPS receiver and the centre of the axle under
"B"
4. Under "C", enter the distance between the rear
axle and the coupling point.
The geometry data for the tractor has been
defined.
CMS-I-001263
5. To be able to use the geometry data,
enable the "Send geometry data" function in the
"Tractor data" menu.
CMS-I-001643
9 | Configuring tractors
Editing the tractor geometry data
MG5560-EN-II | E.1 | 21.04.2020
50
To Next Page
Loading...
