Message Cause Remedy
Manual assignments to this function
are not permitted.
The allocation for this function is
pre-defined by the device and it
cannot be changed.
Error when loading the pool.
Delete the pool for the
corresponding device, see
page 40.
Restart the device.
Several Task Controllers have been
detected with the same TC-ID. Check
ISOBUS settings.
All the terminals connected must
have different TC IDs.
Check the ISOBUS settings, see
page 24
Several terminals with the same UT-
ID have been detected. Check
ISOBUS settings.
All the terminals connected must
have different UT IDs.
Check the ISOBUS settings, see
page 24
GPS receiver not initialised. GPS
receiver is resetting.
Receiver not yet completely
loaded.
Wait, or restart the GPS receiver if
necessary.
Light bar active. The parameters
cannot be read.
Deactivate the light bar in the
settings, see page 29.
Repeat the process.
MG5560-EN-II | E.1 | 21.04.2020
134
To Next Page
