With these settings, the automatic part-width section
control can be overridden to adjust the automatic
part-width section control for individual requirements.
11.1.2.2 Track guidance with GPS track
Track lines can be created on the AMATRON 3 to
support the driver in working the field seamlessly.
After the track lines have been created, they are
shown on the map.
The following track line patterns are available:
A-B line: Straight track line between two points
A+: Straight track line at an angle
Contour: Curved track line in the shape of the
driven line
To ensure that the driver can follow the track lines
reliably, the light bar is shown at the top edge of the
map. The light bar consists of triangular symbols that
show the deviation from the track. The enables the
driver to countersteer accordingly.
NOTE
This application is activated for a period of use of
50 hours. To be able to use the application
without restrictions, a license key must be
purchased from AMAZONE.
CMS-I-001529
11.1.2.3
Variable rate control with GPS maps
GPS maps enables importing and use of application
maps in shape format. Application maps can be used
to control an element of a connected implement. For
example, the application rates for a sprayer and the
spread rates for a spreader or seed drill can be
controlled.
NOTE
To be able to use this function without restrictions,
a license key must be purchased from
AMAZONE.
CMS-I-001530
CMS-T-004867-A.1
CMS-T-004852-A.1
11 | Using the GPS switch
GPS switch overview
MG5560-EN-II | E.1 | 21.04.2020
78
To Next Page
Loading...
