Possible switch points:
Field boundary
Headland boundary
Boundary between the worked and unworked
areas
NOTE
For more information on how the driver
assistance system is used, see page 124.
REQUIREMENTS
For AMABUS seed drills:
Seed drill is connected
The AMATRON 3 is started in AMABUS mode,
see page 15
Seed drill is selected in the implement menu,
see page 45
For ISOBUS seed drills:
Seed drill is connected
The AMATRON 3 is started in ISOBUS mode,
see page 15
1. Select "GPS switch" > > "Driver assistance
system".
2. Enter the desired distance and confirm
or
If the driver assistance system should be
disabled,
enter "0" and confirm
CMS-I-001726
11 | Using the GPS switch
Entering the basic settings for GPS switch
MG5560-EN-II | E.1 | 21.04.2020
86
To Next Page
Loading...
Need help?
General
