3-18 Electromagnetic Field (EMF) Measurements (Option 444) Spectrum Analyzer Measurements
3-86 PN: 10580-00447 Rev. H Spectrum Analyzer MG
3-18 Electromagnetic Field (EMF) Measurements (Option 444)
To select EMF measurement go to main menu and press MEASURE > MEASUREMENT >EMF measurement.
The EMF measurement is set up using the “SETUP Menu (EMF Measurement)” on page 3-90. This section
describes the Electromagnetic Field (EMF) measurement functions available with Option 444. Option 444
must be used in conjunction with an Anritsu isotropic antenna at a frequency range that is within specification
of the instrument and antenna used. Refer to your technical data sheet for compatible antennas.
For broadband EMF Meter compliance testing, refer to EMF Meter measurement guide (10580-00489).
Connecting the Antenna
1. Connect the antenna RF connector to the RF In port on the instrument. See Figure 3-71. The antenna
connector must be finger tight.
2. Connect the antenna USB connector to one of the top panel USB Type A ports.
3. Set up a spectrum analyzer measurement for your signal and bandwidth of interest. The frequency
range and span must be set within the operating range of the antenna.
4. While in Spectrum Analyzer mode, press MEASURE > MEASUREMENT > EMF Measurement.
Note
EMF measurements require that an Anritsu EMF isotropic antenna is connected to the analyzer and
that the frequency range and span is set within the operating range of the antenna.
To Next Page
Loading...
