Anritsu MS9740B - Page 303

Appendix C Message Lists
C-5
Appendix C
Table C-1 Error Message List (Cont'd)
Message Phenomenon
Save file name not specified
The file name to be saved is not specified.
Selected item is empty.
There is no file on the specified device.
Selected TCP Port Number busy
Change TCP Port Number.
The selected TCP port number is in use.
Change the TCP port number.
Set Display of Active Trace to On.
Peak Search or Dip Search was executed while
Active Trace was set to Display Off. Set to
display the Active Trace.
Set Span larger than 0.
Set the span during Zone Marker display to a
value larger than 0 nm.
Slit 1 error in Optical Unit
An abnormality occurred in Slit 1 at start-up.
Slit 2 error in Optical Unit
An abnormality occurred in Slit 2 at start-up.
Specified file already exists
There is already a file with the same name.
Storage Mode enabled only when Write set for
Trace Type of active trace
Storage Mode can only be set when Trace Type of
Active Trace is Write.
Target device full
The output target device is full.
The file has not been selected.
No file has been selected for operation.
The installation execution file is not found.
There is no installation file on the specified
device.
The license file is not found.
There is no license file on the specified device.
This application has performed an illegal
operation and will be shut down.
An error has caused shutdown.
This operation is not acceptable when unit of
wavelength is frequency.
Change unit from frequency to wavelength.
This operation cannot be performed while the
displayed wavelength unit is set to frequency.
Change the unit from frequency to wavelength.
Trace already in use
The same trace cannot be set at Opt Amp Pin,
Pout, and Pase.
Trace measurement parameters must be same
to calculate between traces
Different trace measurement conditions have
been set at the trace Calculation input.
Undefined error.
Undefined message has occurred.
Warning
Warning
Warning-Auto Measure clears all trace data.
Continue operation?
All wavelengths are deleted when performing
the automatic measurement.
Warning-changing sampling points clears all
trace data.
Change sampling points?
All trace data is deleted when sampling points
are changed. Change sampling points?
Warning-operation sets Trace Type of Trace X to
Blank.
Continue operation?
Executing this processing sets the Trace X (X:A
to J) trace type to Blank. Execute processing?
Warning-system reset deletes user data in D:
Execute system reset?
Executing system reset deletes all data on drive
D:/. Execute system reset?
Wavelength calibration failed
Wavelength could not be calibrated.