Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Install a new seal and secure a new base plate to the shift
mechanism by bending over the tabs -arrows-.
– Install shift mechanism. Refer to
⇒ “4.2 Selector Mechanism”, page 91 .
– Adjust the selector mechanism. Refer to
⇒ “2.8 Shift Mechanism, Adjusting”, page 69 .
4.4 Transmission, Removing
Special tools and workshop equipment required
♦ Engine Support Bridge -10 - 222 A-
♦ Hook -10 - 222 A /10-
♦ Hose Clamps Up to 25 mm Diameter. -3094-
♦ Transmission Support -3282-
♦ Pin -3282/29-
♦ Adjustment Plate -3282/33-
♦ Engine/Transmission Jack -V.A.G 1383 A-
♦ Engine Support Basic Set -T40091-
♦ Engine Support Supplement Set -T40093-
♦ Adapter -VW 771/40-
♦ Bracket -T10338-
♦ M10x20 bolt
♦ Grease -G 000 450 02-
♦ Grease for clutch disc shaft splines -G 000 100-
Procedure
Note
♦
Observe general repair notes. Refer to
⇒ “1.2 General Repair Information”, page 2 .
♦
Reinstall cable ties that were loosened or cut off during re‐
moval at same locations during installation.
Caution
Risk of destroying electronic components when disconnecting
the battery.
♦ Observe measures for disconnecting battery.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
96 Rep. Gr.34 - Controls, Housing
To Next Page
Loading...
