Audi TT 2007 - Clutch; General Information; Determining Clutch Manufacturer

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
30 – Clutch
1 General Information
⇒ “1.1 Determining Clutch Manufacturer”, page 11
⇒ “1.2 Clutch System, Bleeding”, page 12
⇒ “1.3 Information Regarding the Removal and Installation of the
Clutch Master or Slave Cylinder”, page 13
⇒ “1.4 Clutch Master Cylinder and Clutch Slave Cylinder, Func‐
tion Test”, page 13
1.1 Determining Clutch Manufacturer
Note
A clutch could be installed from either of the manufacturers,
Sachs or LuK.
Clutch makes can be differentiated with transmission installed as
follows:
– Remove noise insulation in center by loosening fasteners
-1 through 4-.
Some recesses -arrows- are located between engine -A- and
transmission -B- in lower area of engine oil pan.
– Through these recesses, inspect the outer contour of the fly‐
wheel.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
1. General Information 11