Audi TT 2007 - Disassembly and Assembly; Differential

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
4 Disassembly and Assembly
⇒ “4.1 Differential”, page 238
4.1 Differential
Special tools and workshop equipment required
♦ Thrust Plate -VW 402-
♦ Punch -VW 408 A-
♦ Punch -VW 411-
♦ Thrust Disc -VW 412-
♦ Press Tube -30 - 23-
♦ Thrust Piece -40-105-
♦ Thrust Pad -3005-
♦ Tube -3259-
♦ Tube -3296-
♦ Assembly Tool -3301-
♦ Press Tool -3345-
♦ -1- Kukko 21/7 internal puller
♦ -2- Kukko 18/1 puller 65-160mm
♦ -3- Separating tool 17/1
♦ -4- Kukko 22/2 counter-support
♦ -3- Kukko puller 204/2
Pulling Outer Race/Tapered Roller Bearing Off Clutch Housing
A - Support , for example -Kukko 22/2-
B - Internal puller 46 to 58 mm , for example -Kukko 21/7-
– Tension internal puller -B- between the outer ring for the ta‐
pered roller bearing and adjustment shim.
Note
After pulling off, check the adjustment shim for damage and re‐
place if necessary.
Pressing in Outer Race/Tapered Roller Bearing into Clutch Hous‐
ing
– Insert the adjustment shim beforehand.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
238 Rep. Gr.39 - Final Drive, Differential