Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove the nuts -2-.
– Remove mounting bracket -1-.
Installing
• Tightening specification, refer to
⇒ “2.2 Pedal Assembly, Master Cylinder Assembly Overview
”, page 17 .
Install in reverse order, paying attention to the following:
Note
♦
Replace self-locking nuts.
♦
Secure all hose connections with hose clamps of the same
type as those equipped by the factory. Refer to the electronic
parts catalog ETKA.
– Insert mounting bracket -1- and tighten nuts -2-.
– Install the hose/line assembly or plastic line. Refer to
⇒ “4.1 Hose/Line Assembly or Plastic Line”, page 29 .
– Bleed the clutch system. Refer to
⇒ “1.2 Clutch System, Bleeding”, page 12 .
– Install the impact bolster ⇒ page 18 .
– Install the left front footwell vent. Refer to ⇒ Heating, Ventila‐
tion and Air Conditioning; Rep. Gr. 87 ; Removal and Instal‐
lation .
– Install the driver side storage compartment. Refer to ⇒ Body
Interior; Rep. Gr. 68 ; Removal and Installation .
4.5 Clutch Position Sensor
Removing
– Disconnect electrical connector -4-.
– Unclip the clutch position sensor -G476- at the clutch master
cylinder in direction of the -arrow- and remove it.
Note
Ignore items -1, 2 and 3-.
Installing
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
36 Rep. Gr.30 - Clutch
To Next Page
Loading...
