Audi TT 2007 - Right Flange Shaft Seat on Outer Bevel Box, Replacing

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove right flange shaft bolt -arrow 1- with the -T10107 A-
by installing 2 bolts in the flange and counter holding the flange
shaft with the assembly lever.
– Install -T10037- on right flange shaft.
– Align -T10037- with knurled nut -T10037- and lower support
-A- parallel to flange.
– Pull out flange shaft.
Installing
• Tightening specification, refer to
⇒ “1.2 Flange Shaft and Seals on Bevel Box Assembly Over‐
view”, page 220 .
Install in reverse order, paying attention to the following:
– Carefully install the flange shaft, while rotating it at the same
time.
– Install flange shaft.
– Install the right drive axle heat shield ⇒ page 113 .
– Install right drive axle. Refer to ⇒ Suspension, Wheels, Steer‐
ing; Rep. Gr. 40 ; Removal and Installation .
– Check the transmission oil level in the manual transmission
and fill. Refer to
⇒ “1.1 Manual Transmission, Checking Gear Oil Level”, page
47 .
3.5 Right Flange Shaft Seat on Outer Bevel
Box, Replacing
Special tools and workshop equipment required
♦ Thrust Piece -T10049-
Procedure
• Transmission installed.
– Remove right flange shaft. Refer to
⇒ “3.4 Right Flange Shaft”, page 230 .
– Pry out the shaft sealing ring for the flange shaft with an as‐
sembly lever.
– Lightly oil outer circumference of new shaft seal.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
3. Removal and Installation 231