Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.16 Shift Mechanism Assembly Overview, Transmission Side
Note
Grease bearing areas and slide surfaces with grease -G 000 450 02- .
1 - Bushing for Selector Shaft
❑ Removing and installing
-16- ⇒ page 82
2 - Selector Shaft
❑ With shift cover
❑ Can be removed and in‐
stalled with transmis‐
sion installed
3 - O-ring
❑ Replace
❑ Insert into surrounding
groove of shift cover
❑ Install coated with gear
oil
4 - Cap for Transmission
Breather
5 - Selector Shaft Seal
❑ Replace, refer to
⇒ “4.14 Selector Shaft
Seal”, page 124
6 - Bolt
❑ Replace
❑ 20 Nm
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
2. Description and Operation 85
To Next Page
Loading...
