Audi TT 2007 - Shift Cable and Selector Cable to Model Year 2007 Assembly Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.5 Shift Cable and Selector Cable to Model Year 2007 Assembly Overview
Note
Grease bearing areas and slide surfaces with grease -G 000 450 02- .
1 - Retaining Washer
2 -
Control Cable Retainer
❑ For the selector cable
on the selector relay lev‐
er
❑ Allocation ⇒ page 62
❑ Release to adjust selec‐
tor mechanism
⇒ page 71
3 - Retaining Washer
4 -
Control Cable Retainer
❑ For shift cable to trans‐
mission shift lever
❑ Allocation ⇒ page 62
❑ Release to adjust selec‐
tor mechanism
⇒ page 71
5 - Bushing
6 - Grommet
7 - Shift Cable
❑ Removing and instal‐
ling, refer to
⇒ “4.3 Shift Cable and
Selector Cable”,
page 94
❑ From VIN 8J-7-013001,
modified attachment to
the shift lever within the
shift mechanism -8-
⇒ page 59
❑ Adjusting, refer to
⇒ “2.8 Shift Mechanism,
Adjusting”, page 69
8 - Lock Washers
❑ No longer used from VIN 8J-7-013001 ⇒ page 59
9 - Circlips
10 - Selector Cable
❑ Removing and installing, refer to ⇒ “4.3 Shift Cable and Selector Cable”, page 94
❑ From VIN 8J-7-013001, modified attachment to the selector bracket within the shift mechanism -6-
⇒ page 59
❑ Adjusting, refer to ⇒ “2.8 Shift Mechanism, Adjusting”, page 69
11 - Bolt
❑ 20 Nm
❑ Quantity 3
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
2. Description and Operation 61