Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Pressing in Tapered Roller Bearing Outer Race into Transmission
Housing
– Install shim under outer race.
– Support transmission housing beneath bearing mount using
-2050- .
3.3 Output Shaft for 5th/6th Gear and Re‐
verse Gear
Special tools and workshop equipment required
♦ Thrust Plate -VW 401-
♦ Thrust Plate -VW 402-
♦ Punch -VW 407-
♦ Punch -VW 408 A-
♦ Thrust Disc -VW 412-
♦ Tube 60 mm Dia. -VW 415 A-
♦ Thrust Pad 16.5/28 mm Dia. -VW 431-
♦ Thrust Tube -VW 455-
♦ Thrust Pad -VW 510-
♦ Tube 42 mm Dia. -VW 516-
♦ Sleeve -VW 519-
♦ Thrust Pad -30 - 11-
♦ Thrust Piece -40 - 105-
♦ Sleeve -40 - 20-
♦ Thrust Plate -2050-
♦ Tube -3296-
♦ Tapered Roller Bearing Puller -V.A.G 1582-
♦ Attachment -V.A.G 1582/4-
♦ Grip -V.A.G 1582/7-
♦ Thrust Pad Con. 8/65 -VW 433-
♦ Thrust Tube -VW 454-
♦ Support Channels -VW 457-
♦ Holding Fixture -VW 801-
♦ Kukko 21/7 internal puller
♦ Separating tool 17/2
♦ Kukko 22/2 counter-support
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
202 Rep. Gr.35 - Gears, Shafts
To Next Page
Loading...
