Audi TT 2007 - Shift Cable and Selector Cable

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Bolt the control cable mounting bracket to the transmission
-arrows-. Tightening specification, refer to
⇒ “2.5 Shift Cable and Selector Cable to Model Year 2007 As‐
sembly Overview ”, page 61 .
– Apply a small amount of grease -G 000 450 02- to the trans‐
mission shift lever pins -arrows- -1- and selector relay lever
-2- if applicable.
• Replace lock washer -3- and, in the case of a metal selector
relay lever, lock washer -4- after each disassembly.
– Install the shift cable and secure with lock washer -3-.
Metal selector relay lever
– Install the selector cable and secure with lock washer -4-.
Plastic selector relay lever
– Insert the selector cable in the control cable retainer.
Continued for all
– Adjust the selector mechanism. Refer to
⇒ “2.8 Shift Mechanism, Adjusting”, page 69 .
– Install the driveshaft. Refer to ⇒ Rear Final Drive 02D, 0AV,
0BR and 0BY; Rep. Gr. 39 ; Removal and Installation
– Place the noise insulation over the shift mechanism and install
the center console. Refer to ⇒ Body Interior; Rep. Gr. 68 ;
Removal and Installation .
– Install the shift knob with the shift lever boot. Refer to
⇒ “4.1 Shift Knob with Shift Lever Boot”, page 90 .
– Install the air filter housing. Refer to ⇒ Fuel Injection and Ig‐
nition; Rep. Gr. 24 ; Removal and Installation .
4.3 Shift Cable and Selector Cable
Removing
– Remove shift mechanism. Refer to
⇒ “4.2 Selector Mechanism”, page 91 .
– Bend open the tabs -arrows- of the base plate for selector
mechanism with a screwdriver and remove the base plate.
– Remove the gasket.
Vehicles to 8J-7-013000
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
94 Rep. Gr.34 - Controls, Housing