Audi TT 2007 - Gear Oil in Bevel Box, Filling

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove oil filler bolt -arrow- in bevel box.
• Target value: the fluid level must reach the lower edge of the
oil filler hole.
– Add gear oil if necessary. Refer to
⇒ “1.3 Gear Oil in Bevel Box, Filling”, page 49 .
Note
Carefully remove leaking oil on bevel box.
– Tighten the new oil filler bolt. Tightening specification
⇒ page 87
– Install the noise insulation. Refer to ⇒ Body Exterior; Rep. Gr.
66 ; Removal and Installation .
1.3 Gear Oil in Bevel Box, Filling
Special tools and workshop equipment required
♦ Used Oil Collecting and Extracting Device -V.A.G 1782-
♦ Charging Device F/haldex 2 Coup. -VAS 6291-
Procedure
• Vehicle must be level
• Bevel box must be in installation location.
• Tightening specification, refer to
⇒ “3.1 Bevel Box Oil Filler Bolt”, page 87 .
– Route the hose of the -VAS 6291- through the engine com‐
partment.
– Remove right drive axle heat shield from bevel box -arrows-.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
1. General Information 49