Audi TT 2007 - Removal and Installation; Shift Knob with Shift Lever Boot

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
4 Removal and Installation
⇒ “4.1 Shift Knob with Shift Lever Boot”, page 90
⇒ “4.2 Selector Mechanism”, page 91
⇒ “4.3 Shift Cable and Selector Cable”, page 94
⇒ “4.4 Transmission, Removing”, page 96
⇒ “4.7 Transmission, Installing”, page 107
⇒ “4.5 Transmission, Transporting”, page 106
⇒ “4.6 Transmission, Securing to Assembly Stand”, page 107
⇒ “4.8 Transmission Mount, Removing”, page 113
⇒ “4.9 Transmission Mount, installing”, page 116
⇒ “4.10 Pendulum Support”, page 117
⇒ “4.11 Bevel Box, Removing”, page 118
⇒ “4.12 Bevel Box, Installing”, page 122
⇒ “4.13 Input Shaft Seal”, page 123
⇒ “4.14 Selector Shaft Seal”, page 124
⇒ “4.15 Selector Shaft”, page 126
4.1 Shift Knob with Shift Lever Boot
Note
The shift knob is removed together with the shift lever boot and
the center console cover.
Special tools and workshop equipment required
♦ Trim Removal Wedge -3409-
♦ Hose Clip Pliers -V.A.G 1275-
Removing
– Open the ashtray.
– Carefully pry trim from center console -arrows-.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
90 Rep. Gr.34 - Controls, Housing