Audi TT 2007 - Page 95

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Manual Transmission Mount on Engine
Item
Bolt
1
Nm
1
2)
,
3
3)
M12x55 80
2
4)
M12x65 80
M12x55 80
4
4)
,
5
4)5)
M10x50 40
6
3)
M12x80 80
A Alignment sleeves for centering
•
1)
Replace bolts.
•
2)
Bolt with 8 mm threaded pin
•
3)
With permanent washer.
•
4)
Bolted from the engine side into the transmission.
•
5)
The securing clip must be inserted in the engine oil pan
Bevel Box Bracket -A- Tightening Specification and Sequence
– Tighten bolts in 4 stages as follows:
1. Install bolts -1- and -2- hand tight.
2. Pretighten bolts -1- to 3 Nm.
3. Tighten bolts -2- to 35 Nm.
4. Tighten bolts -1- to 45 Nm.
Right Drive Axle Heat Shield - Tightening Specification
– Tighten bolts -arrows- to 25 Nm.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
3. Specifications 89