Audi TT 2007 - Selector Shaft

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Drive in the shaft sealing ring using the sleeve -VW 423- .
– Install the transmission shift lever and selector relay lever. Re‐
fer to
⇒ “2.6 Transmission Shift Lever and Selector Relay Lever to
Model Year 2007 Assembly Overview”, page 63 or
⇒ “2.7 Shift Cable and Selector Cable from Model Year 2008
Assembly Overview ”, page 65 .
Note
The transmission shift lever can only be inserted in one position.
– Install the air filter housing. Refer to ⇒ Fuel Injection and Ig‐
nition; Rep. Gr. 24 ; Removal and Installation .
4.15 Selector Shaft
Removing
– Completely remove the air filter housing. Refer to ⇒ Fuel In‐
jection and Ignition; Rep. Gr. 24 ; Removal and Installation .
Plastic selector relay lever -1-:
– Pull the securing mechanism forward as far as the stop in di‐
rection of -arrow 1- and then unlock to the left in direction of
-arrow 2-.
– Press the selector relay lever forward in direction of
-arrow 3- while pulling the selector cable out of the control ca‐
ble retainer.
– Remove the selector relay lever with catch to Model Year 2007
⇒ page 64
– Remove the selector relay lever with catch from Model Year
2008 ⇒ page 69
Metal selector relay lever
– Pull off lock washer -2- and press selector relay lever -3- to the
side and out of the bearing.
All Vehicles
Note
If the selector relay lever cannot be removed due to the trans‐
mission bracket, remove the selector cable from the selector relay
lever. Remove the slide shoe from the transmission shift lever.
– Remove nut -4- and remove transmission shift lever -1-.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
126 Rep. Gr.34 - Controls, Housing