Audi TT 2007 - Gears, Shafts; General Information; Grooved Ball Bearing Changes

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
35 – Gears, Shafts
1 General Information
⇒ “1.1 Grooved Ball Bearing Changes”, page 177
1.1 Grooved Ball Bearing Changes
From transmission build date 4.10.06 through approximately
1.21.08
A spacer washer above and below the grooved ball bearing seat
-6- ⇒ page 180 .
Above the Bearing Seat
Bearing Seat Spacer Washer
Above the Bearing
Seat
Through transmis‐
sion build date 09 04
6
Dimension “a” 10
mm
No
From transmission
build date 4.10.06
through approxi‐
mately 1.20.08
Dimension “a” 10.7
mm
Yes
Approximately from
transmission build
date 21 01 8
Below the bearing
seat
flattened area for
the grooved ball
bearing
No
Below the Bearing Seat -arrow-:
Slightly deeper from transmission build date 4/10/06 through ap‐
proximately 1/20/08.
The grooved ball bearing seat -arrow- is slightly deeper in order
to accommodate the spacer washer under the bearing -6-
⇒ page 180 .
Below the Bearing Seat Spacer Washer Un‐
der the Bearing Seat
Through transmis‐
sion build date
4.9.06
Not deeper. No
From transmission
build date 4.10.06
through approxi‐
mately 1.20.08
Slightly deeper. Yes
Approximately from
transmission build
date 21 01 8
Flattened area -B-
for the grooved ball
bearing -A-
No
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
1. General Information 177