Audi TT 2007 - Hydraulics Assembly Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.3 Hydraulics Assembly Overview
1 - Brake Fluid Reservoir
2 - Spring-Type Clamp
❑ Not equipped on all ve‐
hicles
3 - Supply Hose
❑ Made of rubber or plas‐
tic depending on the
version
❑ Plastic return hose with
additional seals
⇒ page 20
4 - Clutch Master Cylinder
❑ Removing and instal‐
ling, refer to
⇒ “4.6 Master Cylinder”,
page 37
5 - Clip
❑ To remove and install
the hose/line assembly,
pull the clip out to the
stop
6 - Sealing Ring or O-ring
❑ Replace damaged seal‐
ing rings or O-rings
❑ Pull onto line connection
❑ Install with brake fluid
❑ Seals/O-rings suitable
for the line connection
material ⇒ page 20
❑ Allocation, refer to the
electronic parts catalog
ETKA
7 - Mounting Clip
❑ To remove and install, disconnect the clutch master cylinder from the clutch pedal. Refer to
⇒ “4.3 Clutch Pedal”, page 32
8 - Clutch Pedal
❑ Removing and installing, refer to ⇒ “4.3 Clutch Pedal”, page 32
9 - Nut
❑ For the bracket to the bulkhead
❑ Tightening specification -15- ⇒ page 18
10 - Hose/Line Assembly
❑ Removing and installing, refer to ⇒ “4.1 Hose/Line Assembly or Plastic Line”, page 29
❑ Equipment depends on version
❑ Allocation, refer to the electronic parts catalog ETKA
11 - Bracket
❑ For hose/line assembly -10-
❑ Secured to body
❑ Bracket differentiation ⇒ page 21
12 - Plastic Line
❑ Removing and installing, refer to ⇒ “4.1 Hose/Line Assembly or Plastic Line”, page 29
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
2. Description and Operation 19