Audi TT 2007 - Page 26

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
❑ Equipment depends on version
❑ Allocation, refer to the electronic parts catalog ETKA
13 - Bracket
❑ For plastic line -12-
❑ Secured to body
❑ Bracket differentiation ⇒ page 21
14 - Sealing Ring or O-ring
❑ Replace damaged sealing rings or O-rings
❑ Pull onto line connection
❑ Install with brake fluid
❑ Seals/O-rings suitable for the line connection material ⇒ page 20
❑ Allocation, refer to the electronic parts catalog ETKA
15 - Bleeder
16 - Clip
❑ To remove and install hose/line assembly or bleeder, pull out clip until stop
17 -
Vent Screw
❑ 4.5 Nm
❑ Clutch system, bleeding, refer to ⇒ “1.2 Clutch System, Bleeding”, page 12
18 - Dust Cap
19 - Clutch Slave Cylinder with Release Bearing
❑ Can only be replaced when transmission is removed
20 - Transmission
O-ring or Sealing Ring for the Hose/Line Assembly or Plastic Line
1 - O-ring
♦ Line connection with circumferential groove -arrow 1-
♦ Check the O-ring for damage and replace if necessary.
2 - Oil seal
♦ Line connection with shoulder -arrow 2-
♦ Prior to installation, place sealing ring -2- on the line connec‐
tion -arrow 2-
Vehicles with Plastic Return Hose -1-
• Seals -2- must be located in supply hose.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
20 Rep. Gr.30 - Clutch