Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Check O-ring -3- for damage and replace if necessary.
– Press bleeder -4- onto clutch slave cylinder connection -1- un‐
til securing clip -2- engages audibly.
– Pull on the bleeder to verify.
– Bleed the clutch system. Refer to
⇒ “1.2 Clutch System, Bleeding”, page 12 .
4.8 Sachs Clutch
Special tools and workshop equipment required
♦ Flywheel Retainer -3067-
♦ Centering Pin -T10097-
♦ Grease for clutch disc shaft splines -G 000 100-
Removing
• Transmission removed, refer to
⇒ “4.4 Transmission, Removing”, page 96 .
When removing, loosen the bolts as follows, so that the pressure
plate does not distort (causing shuddering on acceleration):
– Insert -3067- to loosen bolts.
– Loosen all 6 bolts clockwise, one after the other and in steps
of 90° (
1
/
4
turn) until the pressure plate is free.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
40 Rep. Gr.30 - Clutch
To Next Page
Loading...
