Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.4 Shift Lever and Shift Housing for Vehicles from VIN 8J-7-013001 Assembly
Overview
Note
♦
Lubricate mounting areas and slide surfaces with grease -G 000 450 02- .
♦
Selector mechanism, disassembling and assembling, refer to ⇒ “5.1 Selector Mechanism”, page 128 .
1 - Base Plate
❑ Always replace
❑ Bend open tabs to re‐
move
2 - Gasket
❑ Replace
3 - Selector Lever
❑ Can be removed and in‐
stalled with the shift lev‐
er guide installed -15-
4 - Damping Washer
❑ Slide out of shift lever as
far as stop -arrow-
5 - Retaining Clip
❑ Replace
❑ Do not damage cables
when removing
6 -
Selector Cable
❑ Pry off of selector brack‐
et
❑ Press onto selector
bracket inside the shift
mechanism
❑ Installation location, re‐
fer to
⇒ “2.1 Selector Mecha‐
nism Overview”,
page 52
7 - Bushing
8 -
Shift Cable
❑ Pry off of shift lever guide
❑ Press onto shift lever guide inside the shift mechanism
❑ Installation location, refer to ⇒ “2.1 Selector Mechanism Overview”, page 52
9 - Damper
10 - Bearing Shell
❑ Replace
❑ Is damaged during removal
11 - Bushing
12 - Retaining Washer
❑ Removing and installing ⇒ page 58
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
2. Description and Operation 59
To Next Page
Loading...
