Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Insert -3067- .
– Position the pressure plate on the alignment pins.
– To center the clutch plate, use the -T10097- .
Install the pressure plate as follows so that the pressure plate
does not distort during installation (causing shuddering during
acceleration):
– Make sure that the stop pin (locator) -arrow- can be moved
easily.
– Install all 6 bolts evenly, by hand, until the bolt heads contact
the pressure plate.
– Tighten all 6 bolts clockwise, one after the other and in steps
of 90° (
1
/
4
turn) until the housing contacts the flywheel.
• When doing this, the stop pin -arrow- must lift off from the
pressure plate.
– Tighten all 6 bolts clockwise, one after the other to tightening
specification. Tightening specification -4- ⇒ page 23 .
4.9 LuK Clutch
Special tools and workshop equipment required
♦ Flywheel Retainer -3067-
♦ Centering Pin -T10097-
♦ Grease for clutch disc shaft splines -G 000 100-
Removing
• Transmission removed, refer to
⇒ “4.4 Transmission, Removing”, page 96 .
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
42 Rep. Gr.30 - Clutch
To Next Page
Loading...
