Audi TT 2007 - Over-Center Spring

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– For removal, use a screwdriver to release securing clip -2- on
the bleeder and remove hose/line assembly -4- or plastic line
with O-ring -3- from bleeder -1-.
Installing
Install in reverse order, paying attention to the following:
Note
O-rings -2- or sealing rings - differentiation ⇒ page 20
– Check O-ring -2- for damage and replace if necessary.
– Press hose/line assembly -1- or the plastic line onto clutch
master cylinder connection -4- until securing clip -3- engages
audibly.
– Pull on the line to check.
– Check O-ring -3- for damage and replace if necessary.
– Press hose/line assembly -4- or the plastic line onto the bleed‐
er connection until securing clip -2- engages audibly.
– Pull on the line to check.
– Bleed the clutch system. Refer to
⇒ “1.2 Clutch System, Bleeding”, page 12 .
4.2 Over-Center Spring
Special tools and workshop equipment required
♦ Assembly Tool -T10178-
♦ Grease -G 000 450 02-
Removing
• Mounting bracket for clutch pedal installed in vehicle.
– Move driver seat toward the rear.
– Remove the driver side storage compartment. Refer to ⇒
Body Interior; Rep. Gr. 68 ; Removal and Installation .
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
30 Rep. Gr.30 - Clutch