Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Place over-center spring -2- in the bearing bracket from above
and hold the end of the spring in the installation position with
the -T10178- .
• The over-center spring mounting cup -arrow- must be vertical.
– Insert clutch pedal pressure tab -A- in over-center spring
mounting cup -arrow-.
– Press on clutch pedal slightly, push bolt through and tighten
self-locking nut.
– Install the impact bolster ⇒ page 18 .
– Install the left front footwell vent. Refer to ⇒ Heating, Ventila‐
tion and Air Conditioning; Rep. Gr. 87 ; Removal and Instal‐
lation .
– Install the driver side storage compartment. Refer to ⇒ Body
Interior; Rep. Gr. 68 ; Removal and Installation .
4.3 Clutch Pedal
Special tools and workshop equipment required
♦ Pliers -T10005-
♦ Assembly Tool -T10178-
♦ Grease -G 000 450 02-
Removing
• Mounting bracket for clutch pedal installed in vehicle.
– Move driver seat toward the rear.
– Remove the driver side storage compartment. Refer to ⇒
Body Interior; Rep. Gr. 68 ; Removal and Installation .
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
32 Rep. Gr.30 - Clutch
To Next Page
Loading...
