Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Pull out flange shaft seal using -T20143/2- .
– Lightly oil outer circumference of new shaft seal.
– Drive in new shaft seal as far as stop without tilting it.
– Fill area between sealing lip and dust lip -arrow- halfway with
sealing grease -G 052 128 A1- .
– Install left flange shaft. Refer to
⇒ “3.1 Left Flange Shaft”, page 228 .
– Check the transmission oil level in the manual transmission
and fill. Refer to
⇒ “1.1 Manual Transmission, Checking Gear Oil Level”, page
47 .
3.3 Shaft Sealing Ring for Bevel Box with
Manual Transmission Installed, Replac‐
ing
Special tools and workshop equipment required
♦ Oil Collecting and Extracting Device -V.A.G 1782-
♦ Pulling Hook -T20143/2-
♦ Thrust Piece -T10243-
Procedure
• The bevel box is removed. Refer to
⇒ “4.11 Bevel Box, Removing”, page 118 .
– Place drip tray -VAS 6208- underneath.
– Pry the bevel box shaft sealing ring off with the -T20143/2- or
extractor lever -VW 681- .
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
3. Removal and Installation 229
To Next Page
Loading...
