Audi TT 2007 - Clutch Housing Assembly Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.15 Clutch Housing Assembly Overview
1 - Bushing for Selector Rods
❑ Pulling out ⇒ page 158
❑ Driving in ⇒ page 158
2 - Axle for Reverse Gear Shift
Fork
❑ Installed to transmission
build date 5/24/09
⇒ page 84
❑ Axle cannot be removed
with workshop equip‐
ment
❑ To transmission build
date 5/24/09: When us‐
ing a new clutch hous‐
ing, a new axle must be
pressed in ⇒ page 159
❑ No longer used as of
transmission build date
5/25/09; then bearing of
the reverse gear shift
fork together with the
5th/6th gear shift fork
⇒ page 147
❑ Allocation, refer to the
electronic parts catalog
ETKA
3 - Needle Bearing for Reverse
Shaft
❑ Replace after each dis‐
assembly
❑ Pulling out ⇒ page 159
❑ Installing ⇒ page 159
4 - Alignment Bushing
❑ Quantity: 2
5 - Clutch Housing
❑ When replacing: adjust the output shaft and differential, refer to
⇒ “1.4 Adjustment Overview”, page 224
6 - Input Shaft Seal
❑ Replace, refer to ⇒ “4.13 Input Shaft Seal”, page 123
7 - Shaft Seal
❑ Between manual transmission and bevel box
❑ Replace with transmission installed, refer to
⇒ “3.3 Shaft Sealing Ring for Bevel Box with Manual Transmission Installed, Replacing”, page 229
❑ Can be removed using the sleeve -30 - 21- when the transmission is disassembled.
❑ Can be driven in to stop on disassembled transmission with thrust piece -T40007-
8 - Adjustment Shim
❑ For the differential
❑ Installed position: shoulder on inner diameter faces shaft sealing ring -7-
9 - Taper Roller Bearing Outer Race
❑ For the differential
❑ Removing and installing, refer to ⇒ “1.3 Differential Assembly Overview”, page 222
❑ When replacing: adjust the differential, refer to ⇒ “1.5 Differential, Adjusting”, page 224
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
2. Description and Operation 83