❑ Lock sleeve without shoulder, driving in ⇒ page 156
9 - Needle Bearing for Reverse Shaft
❑ Replace after each disassembly
❑ Pulling out ⇒ page 156
❑ Installing ⇒ page 156
10 - Taper Roller Bearing Outer Race
❑ For output shaft 5th/6th gear/reverse gear
❑ Removing and installing, refer to ⇒ “3.3 Output Shaft for 5th/6th Gear and Reverse Gear”, page 202
❑ In the event of replacement: adjust the output shaft for 5th/6th gear/reverse gear, refer to
⇒ “2.5 Output Shaft for 5th/6th Gear and Reverse Gear, Adjusting”, page 188
11 - Adjustment Shim
❑ For output shaft 5th/6th gear/reverse gear
❑ Adjustment overview, refer to ⇒ “1.4 Adjustment Overview”, page 224
12 - Taper Roller Bearing Outer Race
❑ For output shaft for 1st to 4th gear
❑ Removing and installing, refer to ⇒ “3.2 Output Shaft, 1st to 4th Gears”, page 194
❑ In the event of replacement: adjust the output shaft for 1st to 4th gear, refer to
⇒ “2.3 Output Shaft, 1st to 4th Gears, Adjusting”, page 183
13 - Adjustment Shim
❑ For output shaft for 1st to 4th gear
❑ Adjustment overview, refer to ⇒ “1.4 Adjustment Overview”, page 224
14 - Taper Roller Bearing Outer Race
❑ for the differential
❑ Removing and installing, refer to ⇒ “1.3 Differential Assembly Overview”, page 222
❑ When replacing: adjust the differential, refer to ⇒ “1.4 Adjustment Overview”, page 224
15 - Adjustment Shim
❑ For the differential
❑ Adjustment overview, refer to ⇒ “1.4 Adjustment Overview”, page 224
16 -
Bushing for Selector Shaft
❑ Pulling out ⇒ page 157
❑ Driving in ⇒ page 157
17 - Sealing Plug
❑ Driving out ⇒ page 157
❑ Driving in ⇒ page 157
18 - Left Flange Shaft Seal
❑ Replace, refer to ⇒ “3.2 Left Flange Shaft Seal”, page 228
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
82 Rep. Gr.34 - Controls, Housing
To Next Page
