Audi TT 2007 - Final Drive, Differential; Description and Operation; Flange Shaft and Seals on Transmission Assembly Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
39 – Final Drive, Differential
1 Description and Operation
⇒ “1.1 Flange Shaft and Seals on Transmission Assembly Over‐
view”, page 219
⇒ “1.2 Flange Shaft and Seals on Bevel Box Assembly Overview”,
page 220
⇒ “1.3 Differential Assembly Overview”, page 222
⇒ “1.4 Adjustment Overview”, page 224
⇒ “1.5 Differential, Adjusting”, page 224
1.1 Flange Shaft and Seals on Transmission Assembly Overview
1 - Shaft Seal
❑ Between the bevel box
and transmission
❑ Replace with transmis‐
sion installed, refer to
⇒ “3.3 Shaft Sealing
Ring for Bevel Box with
Manual Transmission
Installed, Replacing”,
page 229
2 - Selector Shaft Seal
❑ Replace, refer to
⇒ “4.14 Selector Shaft
Seal”, page 124
3 - Transmission Shift Lever
4 - Nut
❑ Tightening specification
-8- ⇒ page 63
5 - Left Flange Shaft Seal
❑ Replace, refer to
⇒ “3.2 Left Flange Shaft
Seal”, page 228
6 - Flange Shaft, Left
❑ Removing and instal‐
ling, refer to
⇒ “3.1 Left Flange
Shaft”, page 228
7 -
Bolt
❑ Replace
❑ 33 Nm
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
1. Description and Operation 219