Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
34 – Controls, Housing
1 General Information
⇒ “1.1 Manual Transmission, Checking Gear Oil Level”,
page 47
⇒ “1.2 Gear Oil in Bevel Box, Checking”, page 48
⇒ “1.3 Gear Oil in Bevel Box, Filling”, page 49
1.1 Manual Transmission, Checking Gear
Oil Level
Note
♦
The manual transmission and bevel box have separate sup‐
plies.
♦
Axle oil level in bevel box, checking. Refer to
⇒ “1.2 Gear Oil in Bevel Box, Checking”, page 48 .
♦
Transmission oil specification, refer to the electronic parts cat‐
alog ETKA.
Special tools and workshop equipment required
♦ Triple Square Socket Driver -3357-
♦ Used Oil Collecting and Extracting Device -V.A.G 1782-
Procedure
• Tightening specification, refer to
⇒ “3.2 Manual Transmission Oil Filler Plug”, page 87 .
– Drive the vehicle onto a 4-column lift or over a service pit so
that it is level.
– Remove noise insulation in center by loosening fasteners
-1 through 4-.
– Place the -V.A.G 1782- under the transmission.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
1. General Information 47