Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Fill area between sealing lip and dust lip -arrow- halfway with
sealing grease -G 052 128 A1- .
– Drive in shaft seal as far as stop with -T10298- .
3.8 Bevel Box Drive Flange Seal
Special tools and workshop equipment required
♦ Holding Fixture -VW 313-
♦ Tube 42 mm Dia. -VW 516-
♦ Thrust Piece -40-105-
♦ Thrust Piece -T10049-
♦ Transmission Holder -T10108-
♦ Stop Plate -T10108/1-
♦ Tapered Roller Bearing Puller -V.A.G 1582-
♦ Attachment -V.A.G 1582/6A-
♦ Torque Wrench -V.A.G 1601-
♦ Slide Hammer-Complete Set -VW 771-
♦ Pulling Hook -VW 771/31-
♦ Oil Collecting and Extracting Device -V.A.G 1782-
♦ M10 x 30 bolt (quantity 2)
♦ M12 x 10 nut (quantity 4)
♦ Kukko 20/10 two-arm puller
♦ Kukko 45/2 three arm puller
Procedure
• Tightening specification, refer to
⇒ “1.2 Flange Shaft and Seals on Bevel Box Assembly Over‐
view”, page 220 .
• The bevel box is removed. Refer to
⇒ “4.11 Bevel Box, Removing”, page 118 .
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
234 Rep. Gr.39 - Final Drive, Differential
To Next Page
Loading...
