Audi TT 2007 - Pendulum Support

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– First install transmission bracket on transmission -arrows-.
– Raise transmission with engine support bridge -10 - 222 A-
spindle until transmission bracket -1- touches transmission
mount support arm -2-.
– Next install bolts -arrows- but only tighten by hand.
Caution
Risk of damaging threads in transmission mount support arm
due to bolts inserted crooked.
♦ Before installing bolts -arrows-, transmission bracket -1-
and transmission mount support arm -2- must be abso‐
lutely parallel to each other. If necessary, raise rear of
transmission with trolley jack.
– Only tighten bolts if subframe is installed. Refer to ⇒ Suspen‐
sion, Wheels, Steering; Rep. Gr. 40 ; Removal and Installation
and subframe mounts are adjusted ⇒ Engine Mechanical;
Rep. Gr. 10 ; Description and Operation .
– Remove -10 - 222 A- from engine.
– Install the air filter housing. Refer to ⇒ Fuel Injection and Ig‐
nition; Rep. Gr. 24 ; Removal and Installation .
4.10 Pendulum Support
Removing
– Remove noise insulation in center by loosening fasteners
-1 through 4-.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
4. Removal and Installation 117