Audi TT 2007 - Subframe Mount Assembly Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Turn lock elbow -A- back into starting position in direction of
-arrow 2- and remove from transmission in direction of
-arrow 1-.
– Pull the -T10027 A- out of the selector mechanism.
Shift lever adjustment, checking
• The shift lever must be in the 3rd/4th gear shift gate when the
transmission is in neutral.
– Actuate clutch.
– Select all gears several times. Pay particular attention to the
operation of the reverse gear lock
• The shift lever must move automatically from the reverse gear
shift gate into the 3rd/4th gear shift gate.
If hooking occurs during repeated selection of a gear, the selector
mechanism must be adjusted again.
– Install the center console cover and trim.
– Install the air filter housing. Refer to ⇒ Fuel Injection and Ig‐
nition; Rep. Gr. 24 ; Removal and Installation .
2.9 Subframe Mount Assembly Overview
1 - Bolt
❑ Replace
❑ 60 Nm plus an addition‐
al 90° turn
❑ Transmission console
to transmission
2 -
Bolts
❑ Pendulum support to
transmission
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
72 Rep. Gr.34 - Controls, Housing