Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Pull outer race/tapered roller bearing out of transmission hous‐
ing.
A - Support , for example -Kukko 22/2-
B - Internal puller 46 to 58 mm , for example -Kukko 21/7-
– Determine the adjustment shim thickness according to the ta‐
ble; part numbers. Refer to the electronic parts catalog ETKA.
– Insert shim of correct thickness.
The following shims are available:
Thickness of Shims in mm
0.65 0.85 1.05 1.25
0.70 0.90 1.10
0.75 0.95 1.15
0.80 1.00 1.20
Different shim thicknesses make it possible to select the required
thickness precisely.
If the measured shim thickness is greater than the one listed in
the table, two adjustment shims totaling the correct value can be
installed. First the thicker adjustment shim must be inserted for
this.
– Press in the outer ring again and fasten the transmission
housing. Refer to
⇒ “2.12 Transmission Housing and Shift Mechanism Assem‐
bly Overview”, page 77 .
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
226 Rep. Gr.39 - Final Drive, Differential
To Next Page
Loading...
