Audi TT 2007 - Seal between Transmission and Bevel Box

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove the circlip -A-.
– Shaft must be rotated while pressing off -arrow- so that the
needle bearing contact surface on shaft is not damaged.
– Shaft must be rotated while pressing on -arrow- so that the
needle bearing contact surface on shaft is not damaged.
– Secure the needle bearing with a new circlip.
– Install right flange shaft. Refer to
⇒ “3.4 Right Flange Shaft”, page 230 .
3.7 Seal between Transmission and Bevel
Box
Special tools and workshop equipment required
♦ Pulling Hook -T20143-
♦ Thrust Piece -T10298-
Procedure
• The bevel box is removed. Refer to
⇒ “4.11 Bevel Box, Removing”, page 118 .
– Pry out sealing ring on bevel box with -T20143/1- or -
T20143/2- .
– Lightly oil outer circumference of new shaft seal.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
3. Removal and Installation 233