Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2 Description and Operation
⇒ “2.1 Input Shaft Assembly Overview”, page 179
⇒ “2.2 Output Shaft for 1st to 4th Gears Assembly Overview”,
page 181
⇒ “2.3 Output Shaft, 1st to 4th Gears, Adjusting”, page 183
⇒ “2.4 Output Shaft for 5th/6th Gear/Reverse Gear Assembly
Overview”, page 187
⇒ “2.5 Output Shaft for 5th/6th Gear and Reverse Gear, Adjust‐
ing”, page 188
2.1 Input Shaft Assembly Overview
Note
♦
Attach transmission to assembly stand. Refer to
⇒ “4.6 Transmission, Securing to Assembly Stand”, page 107 .
♦
When installing new gears, consult technical data. Refer to
⇒ “3.1 Code Letters, Assembly Allocation, Ratios and Capacities”, page 9 .
♦
Lubricate all bearings with gear oil when inserting on input shaft.
1 -
Securing Ring
❑ For the grooved ball
bearing/input shaft -6-
❑ Removing and instal‐
ling, refer to
⇒ “5.2 Transmission
without Circlip A for
Cap/Input Shaft”,
page 131
2 - Spacer Washer
❑ Outer circumference =
78.6 mm
❑ Only insert with the
changed transmission
housing (from transmis‐
sion production date
4.10.06 through approx‐
imately 1.20.08), refer to
⇒ “1.1 Grooved Ball
Bearing Changes”,
page 177
❑ Allocation, refer to the
electronic parts catalog
ETKA
3 -
Transmission Housing
❑ Adapted in the grooved
ball bearing seat area
-6- and spacer washers
-2- and -4- from trans‐
mission build date
4/10/06 through approx‐
imately 1/20/08, refer to
⇒ “1.1 Grooved Ball
Bearing Changes”,
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
2. Description and Operation 179
To Next Page
Loading...
