Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
page 177 .
❑ Flattened areas on grooved ball bearing and bearing seat approximately from transmission build date
1.21.08, refer to ⇒ “1.1 Grooved Ball Bearing Changes”, page 177
❑ Allocation, refer to the electronic parts catalog ETKA
4 - Spacer Washer
❑ Outer circumference = 85 mm
❑ Only insert with the changed transmission housing (from transmission production date 4.10.06 through
approximately 1.20.08), refer to ⇒ “1.1 Grooved Ball Bearing Changes”, page 177
❑ Allocation, refer to the electronic parts catalog ETKA
5 - Securing Ring
❑ When replacing grooved ball bearing -6- and input shaft -8-, determine again ⇒ page 193
6 -
Grooved Ball Bearing
❑ Always replace
❑ Pulling off ⇒ page 192
❑ Installation location ⇒ page 193
❑ Pressing on ⇒ page 193
❑ Flattened areas on grooved ball bearing and bearing seat approximately from transmission build date
1.21.08, refer to ⇒ “1.1 Grooved Ball Bearing Changes”, page 177
7 - 5th Gear Toothed Wheel
❑ Pressing off ⇒ page 192
❑ Installed position: the surrounding groove -arrow- points toward the grooved ball bearing -6-
❑ Pressing on ⇒ page 192
8 - Input Shaft
❑ With 3rd/4th and 6th gear wheels
9 - Roller Bearing
❑ With circlip
❑ Pulling out ⇒ page 194
❑ Installing ⇒ page 194
❑ Installed position: the circlip in bearing points to input shaft
10 - Clutch Housing
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
180 Rep. Gr.35 - Gears, Shafts
To Next Page
Loading...
