Audi TT 2007 - Flange Shaft and Seals on Bevel Box Assembly Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.2 Flange Shaft and Seals on Bevel Box Assembly Overview
1 - Nut
❑ Replace
❑ 480 Nm
2 - Bevel Box Output Flange
3 - Output Flange Cover Cap
❑ Replace if damaged
4 - Shaft Seal
❑ For output flange bevel
box
❑ Replace, refer to
⇒ “3.8 Bevel Box Drive
Flange Seal”,
page 234
5 - Seal on Bevel Box
❑ Between the bevel box
and transmission
❑ Replace, refer to
⇒ “3.7 Seal between
Transmission and Bevel
Box”, page 233
6 - Bevel Box
❑ Removing and instal‐
ling, refer to
⇒ “4.11 Bevel Box, Re‐
moving”, page 118
7 - Drain Plug
❑ 60 Nm
❑ For the oil drain hole for
the bevel box
8 - Shaft Seal
❑ For the right flange shaft
on the outside of the
bevel box
❑ Replace, refer to ⇒ “3.5 Right Flange Shaft Seat on Outer Bevel Box, Replacing”, page 231
9 - Drain Plug
❑ For bevel box oil filler hole
❑ Tightening specification, refer to ⇒ “3.1 Bevel Box Oil Filler Bolt”, page 87
10 -
Bolt
❑ Replace
❑ 40 Nm plus an additional 45° turn
❑ Quantity: 4
❑ Bevel box to transmission
11 - Breather Pipe
12 - Ventilation Cap
13 -
Bolt
❑ Replace
❑ 33 Nm
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
220 Rep. Gr.39 - Final Drive, Differential