Audi TT 2007 - Input Shaft, Output Shafts, Differential, Bevel Box and Selector Rods Assembly Overview

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.13 Input Shaft, Output Shafts, Differential, Bevel Box and Selector Rods As‐
sembly Overview
1 - Output Shaft, 1st to 4th
Gears
❑ Disassembling and as‐
sembling, refer to
⇒ “3.2 Output Shaft, 1st
to 4th Gears”,
page 194
❑ Installation location
⇒ page 80
2 - Selector Rod with Shift Fork
for 1st and 2nd Gear
❑ Installation location
⇒ page 80
3 - Selector Rod with Shift Fork
for 3rd and 4th Gear
❑ Installation location
⇒ page 80
4 - Output Shaft 5th/6th Gear/
Reverse Gear
❑ Disassembling and as‐
sembling, refer to
⇒ “3.3 Output Shaft for
5th/6th Gear and Re‐
verse Gear”, page 202
❑ Installation location
⇒ page 80
5 - Selector Rod with Shift Fork
for 5th and 6th Gear
❑ Installation location
⇒ page 80
6 - Reverse Gear Shift Fork
❑ Installation location
⇒ page 80
7 - Input Shaft
❑ Disassembling and assembling, refer to ⇒ “3.1 Input Shaft”, page 192
❑ Always replace grooved ball bearings on input shaft -6- ⇒ page 180
8 - Reverse Shaft
❑ With thrust washer
9 - Thrust Washer
10 - Bleeder
❑ Connect to clutch slave cylinder -14-
11 - Clutch Housing
12 - Input Shaft Seal
❑ Replace, refer to ⇒ “4.13 Input Shaft Seal”, page 123
13 - O-ring
❑ Always replace
❑ Pull onto line connection
❑ Coat with brake fluid before installing
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
2. Description and Operation 79