Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Tighten 4 bevel box connecting bolts -arrows- (only 3 shown
in illustration) at manual transmission. Tightening specifica‐
tions -10- ⇒ page 220 .
– Install right flange shaft. Refer to
⇒ “1.2 Flange Shaft and Seals on Bevel Box Assembly Over‐
view”, page 220 .
5.3 Transmission with Circlip A for the Cap/
Input Shaft
Transmission with Circlip -A-.
Remove and install the transmission housing, shift mechanism,
input shaft, output shafts, differential bevel box, and selector rods
Special tools and workshop equipment required
♦ Holding Plate -VW 309-
♦ Holding Fixture -VW 313-
♦ Transmission Support -VW 353-
♦ Thrust Tube -VW 455-
♦ Slide Hammer-Complete Set -VW 771-
♦ Kukko 21/1 internal puller
♦ Kukko 17/0 separating tool
♦ Kukko 22/1 counter-support
♦ Bracket -30-211A-
♦ Thrust piece -T10042-
♦ Thrust piece -T10143-
♦ Thrust piece -T40008-
♦ Torque Wrench -V.A.G 1331-
♦ Heat gun -V.A.G 1416-
♦ Drift -T10169-
♦ or Drift -T10362- ⇒ page 155
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
142 Rep. Gr.34 - Controls, Housing
To Next Page
Loading...
