Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Drive in the sealing plug -1- using the -3264- to dimension
-a- = approximately 3 mm under the upper edge of housing.
5.6 Clutch Housing, Servicing
Special tools and workshop equipment required
♦ Punch -VW 407-
♦ Sleeve -30 - 21-
♦ Drift -T10168-
♦ Thrust Piece -T40008-
♦ -1- Kukko 21/2 Internal puller and Kukko 21/4
♦ -4- Kukko support 22/1 and 22/2
Pulling Out Bearing Bushing for Selector Rod
A - Support , for example -Kukko 22/1-
B - Internal puller 14.5 to 18.5 mm , for example -Kukko 21/2-
Driving In Bushing for Selector Rod
– Drive in bushing up to the stop when tool makes contact
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
158 Rep. Gr.34 - Controls, Housing
To Next Page
Loading...
