– Press the engine/transmission assembly to the bulkhead while
carefully guiding the bevel box pin into the flange/driveshaft.
Note
♦
Seal in driveshaft flange must not be damaged when removing
and installing transmission. Replace driveshaft if damaged.
♦
Slip the driveshaft horizontally onto the centering pin.
– Secure the driveshaft with the flexible disk on the bevel box
flange -arrows-. Refer to ⇒ Rear Final Drive 02D, 0AV, 0BR
and 0BY; Rep. Gr. 39 ; Removal and Installation .
– Install pendulum support. Refer to
⇒ “4.10 Pendulum Support”, page 117 .
Note
♦
The holes for the pendulum support on transmissions from
05.28.07 have threaded inserts (for example HeliCoil).
♦
How to recognize: collar on the first thread -arrow-.
♦
Note the correct mounting bolts and tightening specifications
-2- ⇒ page 72 .
– Axle oil level in bevel box, checking. Refer to
⇒ “1.2 Gear Oil in Bevel Box, Checking”, page 48 .
– Check gear oil level in manual transmission. Refer to
⇒ “1.1 Manual Transmission, Checking Gear Oil Level”, page
47 .
– Install the noise insulation frame. Refer to ⇒ Body Exterior;
Rep. Gr. 50 ; Removal and Installation .
– Install the noise insulation. Refer to ⇒ Body Exterior; Rep. Gr.
66 ; Removal and Installation .
– Fill the engine oil. Refer to ⇒ Maintenance Procedures; Rep.
Gr. 03 .
– Install the wheels. Refer to ⇒ Wheel and Tire Guide; Rep. Gr.
44 ; General Information .
4.13 Input Shaft Seal
Special tools and workshop equipment required
♦ Pulling Hook -T20143/1-
♦ Thrust Piece -T40008-
♦ Sealing grease -G 052 128 A1-
Procedure
• Transmission removed, refer of
⇒ “4.4 Transmission, Removing”, page 96 .
– Remove the clutch slave cylinder with release bearing. Refer
to ⇒ “4.7 Slave Cylinder with Release Bearing”, page 39 .
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
4. Removal and Installation 123
To Next Page
Loading...
