Audi TT 2007 - Shift Mechanism, Adjusting

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Remove the Selector Relay Lever “with Clip” from the Transmis‐
sion Shift Lever -arrow 1- and Attach
Removal
– Remove the clip -arrow 1-, and remove the selector relay lever
together with the control cable retainer.
Securing
Note
Grease bearing areas and slide surfaces with grease -G 000 450
02- .
– Insert the selector relay lever together with the control cable
retainer to the stop.
– Press on the clip -arrow 1- while ensuring that it engages se‐
curely.
Note
Ignore -arrow 2-.
Pry the Selector Cable Retainer Out of the Selector Relay Lever
• Selector relay lever removed.
– Apply a flat head screwdriver -A- between bushing -B- and the
selector relay lever.
Press the Selector Cable Retainer onto the Selector Relay Lever
• Selector relay lever removed.
• The cable retainer may only be pressed on at the bushing
-arrow-.
• The control cable retainer must move freely on the selector
relay lever.
• The control cable retainer must be behind the catch.
– Make sure it engages securely.
2.8 Shift Mechanism, Adjusting
Special tools and workshop equipment required
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
2. Description and Operation 69